Wiring conversion Harness possible problem

[USDMem1]

The car is a RHD Australian delivered EM1 and seems I might be missing a wire in the conversion loom and also maybe missing a wire in my OEM EM1's loom.

Here's the problem:
As I was going through the DIY guide for the conversion loom and noticed there is a step where I am meant to splice in a green/red wire labelled 'brake fluid' from the conversion loom into one of the brake reservoir wires. The problem is, that there is no 'brake fluid' wire provided in the HR conversion loom… Not sure why this is to be honest.



Also, the 6 wires that are meant to be joined into OEM connector A. Well the ELD 'grn/red' wire from the conversion loom is meant to go to the GRN/RED wire, A30 from connector A. But in my OEM A connector there is no grn/red wire and no wire in A30 slot. What is the ELD wire for specifically and is it important. For what reason would it not be in my OEM loom?





Thanks for your help guys.

- Mike

[hybridracing]

Disregard this step for 96-00 chassis and we will make the change in the install guide. Thanks for pointing it out!

-Will

[hybridracing]

Ok the new guide is updated and can be found here: http://www.hybrid-racing.com/tech/99...install-guide/

[USDMem1]

Ok cool, but what about that ELD wire? Like I said that 'A30' grn/red wire isn't in my OEM connector A. So therefor I have nothing to connect the ELD wire from the conversion harness to :/

Will this be a big issue?

[USDMem1]

Anyone have any ideas?

[hybridracing]

This should not be an issue.

Sorry for the delay. In the future drop an email to support@hybrid-racing.com and a support ticket will be created!

Thanks,

Will

[USDMem1]

Ok cool, no worries. Thanks mate